Problem with size

[Xizour]

Hello.

I've got a finished flash intro, which I want to be used on html page. Unfortunately, I have problems with correct displaying of it. I use Adobe Flash CS3.

In document, it has a grey border (screenshot 1 - screenshot 1 (http://img3.imageshack.us/img3/4536/xxxwru.png)), but when I try to publicate it, it looks like that - screenshot 2 (http://img3.imageshack.us/img3/8002/xxx2.png). Border disappears. It is not the fault of locating intro in html code, but it's something wrong with .fla file. I don't know, what's the matter. I even tried to change it into non-scale mode, but it doesn't help.

Regards,
Xizour.

[kkbbcute]

Check your publish settings, a setting of 100% of the browser area snaps a little off the top and sides.

[ASWC]

What's the overall size of your graphics on the stage as opposed to the stage size?

[Xizour]

512 x 315 pixels. But I tried to set the size of these two things the same. No effect.

@kkbbcute:
I tried to change almost everything in publish settings. Nothing changed.

[ASWC]

No but what is the size of the stage AND the overall size of the graphics? Because if your graphics are off the stage then they are not displayed.

[Xizour]

I know, that when my graphics are off the stage they are not displayed. Document is 450x253 and overall size of graphics is 512x315.

But as I said previously, I tried to set the size of both stage and graphics into the same size. And it has no effects. Maybe would you like me to give you .fla file? You could look into this.

[ASWC]

reset the stage size to fit the graphic size and then republish since the html you have has still the former size for the swf. So new size for the stage and then new size for the swf in the html and you are all set.

[Xizour]

It works :) Thank you so much.

[ASWC]

You are welcome! Have fun! ;)