How do you call up a movie clip from another flash project?

[oct10]

Hello Guru

How do you call a movie clip from another project.?
and is there a way to copy a scene from another project?

Thanks

[Jesse]

what do you mean 'call'? Have you got two projectors running simulatenously and you want to effect one using the other? If so, I think it's impossible. You can loadmovie or use fscommand and exec to launch another projector, but that's about the extent of my projector interaction knowledge.

[oct10]

Hello Jesse the Guru

I'm doing a one presentation. It has 3 sections and a intro loop. Each section is done by each member. I'm doing the looping intro and the navigation interface.

Now I have the intro movie and the navigation finish. I'm trying to put the other 3 sections that are done by other member into my piece. So you see, it really a 4 flash file.
1. intro movie with Navagation bar to each section
2. section A
3. section B
4. section C

So here is what i did.. In 1.(intro movie) i use command LoadMovie to load 2.(sectionA) it work.. but once in 2. I can't seem to get back to 1. correctly. Plus while in 2. it need to be able to go to 3. and 4.and back to 1.

If I can't use Loadmovie command .. then I would have to copy each .fla file(section A,B,C) and put it in my .fla file, then break it into 4 scene.. This way.. It might be easier to control and easy set the navigation bar.

Do you find any way that will make my life a little easier?
Your help is deeply appreciated..

[Jesse]

what is the loadMovie code you are using? if you can't get back to the first movie you've probably loaded the 2nd incorrectly...