theiceman
02-02-2005, 08:13 PM
When you add a component to your flash movie, the class files are exported on frame 1 by default, but you can change this to prevent large delays when using pre-loaders etc.
However, when I attempt this on my clients site found here: ex-biofusion (http://www.ex-biofusion.com) the class files do NOT seem to load unless put on frame 1. Therefore, there is a small delay for dial-up users before the preloader appears. Please could someone offer a solution or tell me what I might be doing wrong?
Also, anyone using dial up may notice that my thumbnail preloaders and main photo preloader do not work as they should, and instead dissappear too soon as if the content has loaded.The content does not appear for another few seconds though??
The preloaders for the thumbnails work perfect on broadband though??
Any help would be much appreciated.
Kind regards,
Jason
However, when I attempt this on my clients site found here: ex-biofusion (http://www.ex-biofusion.com) the class files do NOT seem to load unless put on frame 1. Therefore, there is a small delay for dial-up users before the preloader appears. Please could someone offer a solution or tell me what I might be doing wrong?
Also, anyone using dial up may notice that my thumbnail preloaders and main photo preloader do not work as they should, and instead dissappear too soon as if the content has loaded.The content does not appear for another few seconds though??
The preloaders for the thumbnails work perfect on broadband though??
Any help would be much appreciated.
Kind regards,
Jason