RandyS
05-31-2005, 05:06 PM
Hi,
This is probably something simple but its driving me nuts. Its an authoring mode preference problem (me thinks).
I'm working on a 1024 X 768 project and when I'm working on the stage on the main timeline I keep the rulers showing and 0,0 is near the top left and I can easily scroll over or hand grab over to the right side in the 1024 area. Everything is fine.
But when I create a new movie clip (F8) the stage is centered with 0,0 in the center and working area of about 1400 X 1400 pixels. So on the ruler the x -axis goes from about -700 to + 700. The problem is that I can't scroll or hand grab the stage and move it over.
Like I say, its driving me nuts. Anyone know how I can reset this?
Thanks,
Randy
This is probably something simple but its driving me nuts. Its an authoring mode preference problem (me thinks).
I'm working on a 1024 X 768 project and when I'm working on the stage on the main timeline I keep the rulers showing and 0,0 is near the top left and I can easily scroll over or hand grab over to the right side in the 1024 area. Everything is fine.
But when I create a new movie clip (F8) the stage is centered with 0,0 in the center and working area of about 1400 X 1400 pixels. So on the ruler the x -axis goes from about -700 to + 700. The problem is that I can't scroll or hand grab the stage and move it over.
Like I say, its driving me nuts. Anyone know how I can reset this?
Thanks,
Randy